Product category:
Industrial Drives/Controls
News Release from: ABB Automation Tech (Drives and Motors) | Subject: Variable speed drives
Edited by the Engineeringtalk Editorial
Team on 14 April 2005
Variable-speed drives power up obsolete
pumps
By converting 50Hz to 40Hz, ABB variable speed drives are saving a fertiliser manufacturer the cost of investing in new pumps and process equipment.
By converting 50Hz to 40Hz, ABB variable speed drives are saving a fertiliser manufacturer the cost of investing in new pumps and process equipment The 40Hz pumps are installed at Terra Nitrogen's Billingham plant and were fitted before 50Hz became the standard frequency for mains supply
This article was originally published on Engineeringtalk on 9 Nov 2001 at 8.00am (UK)
Related stories
Over 100 drives for air handling at hospital
Edinburgh Royal Infirmary, the UK's largest new acute teaching hospital project, is installing ABB variable speed drives to maintain a clean air supply in its operating theatres
Reliable drive key to dust and odour suppressor
Variable speed drives have enabled a northern company to develop a revolutionary new system for removing dust and odours from the atmosphere by reducing the size of the motor needed
Running them with ABB variable speed drives means that the company does not have to replace serviceable equipment in order to use a modern power supply.
Terra Nitrogen is the UK's largest manufacturer of ammonia and fertiliser, having acquired the plant in Teesside from ICI in 1998.
The project, which saw the installation of ABB industrial drives in its demineralisation water plant, came about because of the unusual history of the plant.
Further reading
Drive smoothes laundry service for hospital
Laundry services at The University Hospital of North Staffordshire are running more smoothly and saving 40% on power costs following the fitting of an ABB 22kW motor and variable speed drive.
Drives keep the hammer down at water works
ABB variable speed drives are helping reduce the damaging effects of extreme water turbulence in the pipework - so-called water hammer - at a water treatment works in Scotland.
The site, originally established by ICI in the 1920s, has its own power station to provide steam and electricity.
At the time it was built there was no standard for the frequency of electricity and so ICI chose to generate at 40Hz.
With the advent of the standard 50Hz supply, conversion plant was installed to allow the interconnection of the 40Hz and 50Hz systems.
Although the amount of equipment running on 40Hz declined, the demineralised water plant, which is critical for the process, continued to use 40Hz to run pumps and fans.
After many years' service, the 50Hz to 40Hz conversion equipment was becoming less reliable and expensive to maintain so another solution had to be found.
Harry Summerfield, Terra Nitrogen's Control and Electrical Engineer, says: "The options were either to scrap all the 40Hz equipment and buy new pumps and process equipment or find a modern solution, such as variable speed drives, that could convert 50Hz to 40Hz".
"We had used ABB before and knew the capabilities of their equipment".
The company asked Slater Drive Systems (SDS) to look at the requirement.
SDS' solution was nine ABB variable speed drives ranging from 15 to 55kW.
Stuart Combe of SDS says: "Terra got a number of benefits from this project".
"The first was that they could get rid of the 50Hz to 40Hz conversion equipment, removing the danger that it would become unserviceable and allowing the plant to continue operating".
"It also allows them to save energy by adjusting the plant to the optimum production speed, as well as giving the opportunity to use standard 50Hz equipment".
Summerfield concludes: "It was a very cost effective solution, and meant we did not have to spend money on a lot of new equipment".
• ABB Automation Tech (Drives and Motors): contact details and other news
• Email this article to a colleague
• Register for the free Engineeringtalk email newsletter
• Engineeringtalk Home Page
