Heat recovery cuts energy costs
Direct Air and Pipework has installed a Boge SDF60 frequency controlled compressor on Telford Yarns' yarn twisting machines.
The installation of a heat recovery system fitted to a Boge variable speed compressor reduces system energy costs.
Telford Yarns, a division of Brintons Carpets, is on track to make energy savings of up to GBP 7000 per year following the installation of a Boge compressor system including a heat recovery package.
In addition, the introduction of the Climate Change Levy in April means that the company qualifies for Enhanced Capital Allowances on several elements of the system.
Telford Yarns supplies Brintons' facilities throughout the world and, as the largest yarn manufacturing plant in the Northern hemisphere, uses 18% of the total British wool clip.
Telford Yarns relies on compressed air to run yarn twisting machines, with three shifts in operation for 24 hours a day.
The quality of air is critical as it is in direct contact with the finished product.
Also crucial is consistent air pressure, although the actual demand varies depending on how many of the eight twisting machines are in operation.
Direct Air and Pipework has installed a Boge SDF60 frequency controlled compressor as a replacement for an existing system.
This machine is able to supply between 28 and 113 litres a minute, depending on demand.
With an integral refrigerant dryer, it also meets the requirements for clean, dry air.
In addition to matching air delivery to demand through the use of a variable speed drive, Telford Yarns also makes significant energy savings through a Boge duo-therm heat recovery system.
In phase one, the warm air expelled from the compressor package is used for combustion purposes in a gas-fired dryer.
As air cannot be taken from inside the factory due to the presence of wool fibres, it was previously taken from the exterior of the building.
In winter this meant very low temperatures, which had negative effects on the efficiency of the combustion process.
In phase two, process water for washing yarn is pre-heated in a heat exchanger with the hot oil from the compressor.
The introduction of the Climate Change Levy, under which industry faces a 10% increase in energy costs, was the major factor behind Telford Yarn's decision to re-examine its compressed air supply for potential savings.
Peter Newell, Group Technology Site Services Engineer for Brintons Carpets said, "The Boge system offered the best all round package in terms of energy efficiency and flexibility".
"A big advantage is the fact that it is a complete package with an integral refrigerant dryer and a frequency inverter".
"This saves space and simplifies installation and maintenance".
"We knew what we wanted and Direct Air guided us through the best way to achieve it, the result is a tailor made heat recovery system that meets all our needs".
Not what you're looking for? Search the site.
Articles by product category
- Consultancy and Services (903)
- Machine Building (4,517)
-
Engineering Design Software (6,179)
- Engineering Design Software (12)
- 2D CAD software (200)
- 3D CAD software (1,157)
- FEA and structural analysis software (369)
- Fluid, thermal, noise, vibration software (334)
- Simulation, modelling, validation software (914)
- Rendering, visualisation, styling software (196)
- Materials design and moulding design software (151)
- Process, instrumentation, automation software (258)
- Electrical design software (164)
- Publishing and documentation software (229)
- Maths, charting, statistics, QA software (317)
- Data, document management software (310)
- CAM, CNC, production management software (568)
- File conversion software, data capture (351)
- PLM and collaboration software (649)
-
Drives, Motors and Controls (3,361)
- Drives, Motors and Controls (1)
- Precision Motors and Gears (411)
- Industrial Drives/Controls (1,276)
- Linear Drives and Motors (114)
- Industrial Motors (497)
- Stepper and Servo Drives, Motors, Controls (1,060)
- Small Mechanical Components, Joining, Tools (1,975)
-
Control and Instrumentation (5,028)
- Plantwide control (1,324)
- Plant- and Machine-Wide Communications (1,174)
- Smaller-Sized PLCs (387)
- CNC and Motion Controllers (184)
- Mid-range and Large PLCs (201)
- Power Supplies, Uninterruptible Power (562)
- HMIs/Operator Interfaces (294)
- Logic Controllers, Timers and Relays (96)
- Cabling, Conduit, Signal Conditioning (806)
-
Monitoring, Measurement and Quality (5,459)
- Monitoring, Measurement and Quality (1)
- Data acquisition Software and Communications (494)
- Data Acquisition Hardware and PC I/O Boards (472)
- Electrical and Electronic Testing, PAT Equipment (630)
- Form/co-ordinate, optical, vision instruments (703)
- Gauges, Indicators and Instruments (440)
- Data loggers (422)
- Materials testing equipment (421)
- Telecomms/network test equipment, software etc (154)
- Testing and Calibration Services and Information (500)
- Testing, analysing and monitoring equipment (1,222)
-
Electrical and Electronic Equipment Design (4,160)
- Batteries, chargers and circuit protection (555)
- Connectors, Terminals, Busbars, Slip Rings (679)
- Enclosures and Equipment Cooling Fans (709)
- Knobs, Handles and Enclosure Hardware (420)
- PCs and Embedded Systems (798)
- Electrical and Electronic Subassemblies (369)
- Electrical and Electronic Components (630)
-
Materials and Processing (2,963)
- Materials and Processing (5)
- Materials and components (2,215)
- Rapid Prototyping (458)
- Materials processing and testing (285)
-
Engineering Industry News, Resources (6,093)
- Engineering Industry News, Resources (4)
- Engineering Business News, Views (388)
- Engineering Exhibitions, Events (562)
- Engineering Conferences (425)
- Engineering Seminars (400)
- Engineering Industry Developments, Awards (633)
- Engineering Guides, Newsletters (349)
- Engineering Recruitment, Employment (219)
- Engineering Training Courses (433)
- Engineering Education, Resources, Standards (838)
- Engineering Industry Reports, Surveys (597)
- Electronic Resources for Engineers (278)
- Health and Safety Legislation (402)
- Health and Safety Strategy, Risk Assessment (113)
- Health and Safety Consultancy, Software (175)
- Health and Safety Events, Training, News (277)
-
Powertrain Design (3,598)
- Powertrain Design (2)
- Bearings (939)
- Chains and belts (326)
- Gears, brakes, couplings and engines (1,441)
- Hydraulic Components (471)
- Lubricants (418)
-
Capital Equipment (3,387)
- Capital Equipment (1)
- Manufacturing Machinery and Plant Equipment (468)
- Production line blowers and fans (62)
- Compressors and Air Treatment (510)
- Electronics Manufacturing, Tools, Instruments (192)
- Electrical hardware (131)
- Machinery and Production Equipment (1,093)
- Robotics, Handling and Storage (930)
-
Sensors (7,080)
- Sensors (8)
- Accelerometers and Vibration Sensors (427)
- Loadcells, Force Sensors, Torque Sensors (699)
- Pressure sensors (621)
- Flowmeters and Flow Sensors (618)
- Level Sensors and Leak Detectors (527)
- Linear Position Sensors (399)
- Rotary Position, Tilt and Angular Sensors (546)
- Proximity Sensors (700)
- Gas, Chemical, Radiation, Magnetic Sensors (284)
- Humidity and Environmental Sensors (152)
- Temperature sensors (612)
- Vision and Colour Sensors (1,384)
- Barcode Sensors (103)
- Valves, Pumps, Process Hardware (3,623)
