Product category:
Pressure sensors
News Release from: IFM Electronic | Subject: PIM series pressure sensor
Edited by the Engineeringtalk Editorial
Team on 01 May 2008
Pressure sensors prevent cavitation
damage
The PIM sensor continuously monitors a pump to provide an indication of the operating system pressure and offers independent continuous diagnosis of the pump's condition.
IFM Electronic has released pump diagnostic pressure sensors that detect potential pump damage caused by cavitation, trapped air or gas, blockages and deposits The PIM series pressure sensor can perform two functions in one compact housing: pump monitoring and pressure detection
This article was originally published on Engineeringtalk on 26 Jun 2008 at 8.00am (UK)
Related stories
Gateways take control of AS-i slaves
AS-i gateways come with M4 master profile support for all AS-i slaves from specifications 1.0 to 3.0.
Capacitive sensors can see through walls
Sensors from are optimised for the detection of conductive media through nonmetallic walls or on bypasses.
The sensor continuously monitors a pump to provide an indication of the operating system pressure and offers independent continuous diagnosis of the pump's condition.
Operating as a pump diagnostic sensor, the PIM sensor measures the high-frequency pulsation of a properly operating pump and stores it as a reference.
If changes occur in the system, the pulsations will change.
These changes are immediately detected by the sensor.
If a critical pump condition occurs, such as cavitation, the sensor will provide an alarm signal to a controller.
IFM's condition-based pump monitoring sensor increases machine uptime and reduces damage caused by poor pump operating conditions.
In addition to monitoring a pump, any disturbances around the pump such as trapped air in the medium, clogged filters, deposits in pipes or improperly opened valves are also monitored.
The sensor and its teach function are quickly set up using the numeric pushbutton display.
The sensor's display can display the system pressure and the operating state of the pump via a trend display that graphically depicts the operating state of the pump.
The sensor's second output can be configured as a switching output with hysteresis or window function or as a scalable analogue output.
Due to the high overload resistance of the ceramic capacitive measuring cell, the sensor is suitable for switching off the pump in the event of overpressure.
FDT programming software enables the display of the measured values, analogue output, limit values and the parameter setting of the thresholds for diagnosis.
The stainless steel PIM pressure sensor is designed for sanitary applications and uses a variety of sanitary adapters for a secure fitting in washdown, CIP and SIP conditions.
The sensor is 3A-authorised and meets FDA and EHEDG requirements.
Several M12 cable assemblies designed for wash-down conditions are available from IFM. Request a free brochure from IFM Electronic ...
• IFM Electronic: contact details and other news
• Email this article to a colleague
• Register for the free Engineeringtalk email newsletter
• Engineeringtalk Home Page


