Categories
- Consultancy and Services (875)
- Machine Building (4,294)
- Engineering Design Software (5,988)
- Drives, Motors and Controls (3,162)
- Small Mechanical Components, Joining and Tools (1,886)
- Control and Instrumentation (4,867)
- Monitoring, Measurement and Quality (5,184)
- Electrical and Electronic Equipment Design (3,995)
- Materials and Processing (2,825)
- Engineering Industry News and Resources (6,040)
- Powertrain Design (3,408)
- Capital Equipment (3,250)
- Sensors (6,673)
- Valves, Pumps and other Process Hardware (3,483)
Remanufactured machine tools on display
A
Pennine Automation product story
Edited by the Engineeringtalk editorial team
Feb 7, 2002
Pennine Engineering Group is to hold a two week open viewing show between 25th February and 8th March 2002 to highlight its expansion into large remanufactured machine tools.
Pennine Engineering Group is to hold a two week open viewing show between 25th February and 8th March 2002 to highlight its expansion into large remanufactured machine tools.
Customer machines being remanufactured and retrofitted can be viewed along with new machines under construction.
John Ginley Pennine's, Chief Executive, says: "We recognise that in today's tough competitive market conditions new large machine tool purchases are difficult to justify, with pay back periods running into a number of years.
Remanufacture, while not the panacea for every situation, does allow significantly lower Investment opportunities.
Machines can be obtained at maybe 50% or less than new prices".
The event is spread over two weeks to allow visitors from the UK and overseas to receive individual attention and to see these large accurate machines demonstrated.
Not what you're looking for? Search the site.
Contact Pennine Automation
Related Stories
