Product category:
Testing and Calibration Services and Information
News Release from: Sira | Subject: Standard leak calibration
Edited by the Engineeringtalk Editorial
Team on 03 January 2003
UK accredited calibration for standard
leaks
Sira Test and Certification has a new facility for the calibration of standard leaks.
Sira Test and Certification has a new facility for the calibration of standard leaks The facility is the only one of its kind to receive accreditation from the UK Accreditation Service (UKAS)
This article was originally published on Engineeringtalk on 10 Apr 2000 at 8.00am (UK)
Related stories
Accelerometer calibration - and make it snappy
Sira Test and Certification has developed a fast turnaround accelerometer calibration service.
Single source EMC testing service launched
Sira Test and Certification has formed an alliance to offer a one-stop shop facility for customers who are manufacturing electrical equipment for use in hazardous areas.
The facility finally closes the long-acknowledged gap in the measurement traceability chain associated with leak detection.
A standard leak is essentially a reservoir of known gas with an outlet via an element which allows a nominally fixed throughput of gas molecules.
The most common types are helium leaks where the element is a quartz capsule.
Further reading
Test service gets "results on the table quicker"
Sira Test and Certification has provided testing services for Urenco (Capenhurst) to assist its investigation into the advantages of constant power versus self-regulating heating cables.
Useful free wallchart explains Atex directives
Sira Test and Certification has produced an updated version of its 'Ex Directory' wallchart intended as an information source for both ATEX 100a Directive 94/9/EC and ATEX 137 Directive 1999/92/EC
The throughput of molecules in this case depends on a number of factors, the largest of which is the helium concentration gradient across the quartz capsule.
Assuming this and the other factors can be determined with an appropriate measurement uncertainty, then the leak can be used as a transfer standard to calibrate helium leak testing apparatus.
This then allows for industrial leak detection measurements to be made in accordance with international quality standards (ie with demonstrable measurement traceability).
Standard leaks have been in widespread use within the UK but to date the true value of these has never been fully assessed.
In the last few months Sira Test and Certification, working in conjunction with DERA under a contract from the DTI, has built a suite of standard leak calibration facilities to accommodate the UK's traceability needs.
Some of these are already under Sira's UKAS scope of accreditation in respect of ISO/IEC17025.
The others are on course for accreditation early in 2003.
Sira's current accredited facilities cover the calibration of standard helium leaks in the range 10e-6 to 10e-8mbar l/s.
Calibration is achieved using a comparison technique based around a mass spectrometer against reference leaks calibrated in Germany by PTB (Physikalisch-Technische Bundesanstalt).
Uncertainties as low as 5% can be quoted depending on the exact value of the leak being calibrated.
Additional facilities have also been developed to increase the range such as a primary "pressure rise" technique, which allows for gases other than helium.
The facilities will also include the capability to determine the thermal dependence of the leak element - a very significant factor for many types of leak.
This leak calibration service is of particular relevance to customers from the nuclear industries (both power and reprocessing), to vacuum equipment manufacturers of sealed electronic components (vacuum tubes/lights etc), to optical, decorative and tool coatings plants, pharmaceutical manufacturing and to cable and connection manufacturers.
• Sira: contact details and other news
• Email this article to a colleague
• Register for the free Engineeringtalk email newsletter
• Engineeringtalk Home Page
Search the Pro-Talk network of sites
