Cable shafts suit power drive assemblies

Edited by the Engineeringtalk editorial team Dec 22, 2005

A new series of flexible steel cable shafts designed for power drive assemblies features a vinyl covered flexible steel casing.

A new series of flexible steel cable shafts designed for power drive assemblies has been introduced by Stock Drive Products.

Identified as the A 7Z10- Series, they have a vinyl covered flexible steel casing.

These units range from 0.13 to 0.25in in diameter and from 24 to 36in in length.

The minimum operating radius for 0.13in diameter is 3in, and 4in for all others.

They have a curvature radius ranging from 25 to 4in.

Tel +1 516 328 3300

SDP expands rotating component fastener range
Stock Drive Products has added two more fasteners to its range of Shaftloc products.
Adapters save on special shafting
Stainless-steel shaft adapters are high-precision devices with tight tolerances on bores, shank and bore/shank concentricity.
Magnetic attraction for clutches and couplings
Devices feature no friction or wearing parts, use no electricity and have no magnetic particles to leak.
Catalogue simplifies shaft connections
Fairloc is designed to solve phasing, timing, positioning and frequent removal problems which conventional fastening methods, such as clamps, keyways, pins or set screws, cannot properly handle.
Flexible shafts work without casings
Stock Drive Products' A7C13M and A7C13 flexible shafts are designed to operate in a manual mode and have a curvature radius ranging from 500 to 38mm.

Engineeringtalk