Product category:
Design and Development Consultancy
News Release from: 42 Technology | Subject: Product design
Edited by the Engineeringtalk Editorial
Team on 09 June 2006
Materials choice is key to design
improvement
Work carried out by 42 Technology for Crane Electronics has resulted in modifications to the JRS product that has significantly reduced its weight, while improving its high performance.
Work carried out by 42 Technology for Crane Electronics has resulted in modifications to its JRS product that has significantly reduced its weight, while improving its high performance Crane Electronics, a world leader in torque, angle and pulse measurement and control systems, asked 42 Technology to complete a feasibility study to reduce the size, weight and cost of one of its key products: a joint rate simulator
This article was originally published on Engineeringtalk on 4 Apr 2003 at 8.00am (UK)
Related stories
Telescopic probe aids in-flight refuelling
Having worked with Flight Refuelling for the last four years, Pershore based Accura Geneva has seen the relationship develop into one that is today an example of a true partnership between companies.
Subcontract honing service shows its experience
Apperley Honing's specialist subcontract honing division has seen an 18% increase in sales over the past 12 months.
This is a device which has to simulate torques a wrench would experience in use and is used extensively by automotive and other manufacturing industries for calibrating torque wrenches.
At the heart of the device is a computer controlled friction brake used to retard the rotation of a very low inertia shaft.
An initial study reviewed alternative mechanisms and identified several candidates that might lead to significant improvements.
Further reading
Upside-down joystick aids radiation research
Engineers from Advanced Design Consulting have taken the joystick for the sake of science and turned it upside-down.
Composite fairing is a combined effort
The combined expertise of both Brookhouse Composites and Brookhouse Patterns of Darwen, has been used to produce a specialist composite fairing for an aerospace wind tunnel.
42 Technology also identified that there was significant scope for improving the existing, commercially established mechanism.
42 Technology recommended that the route with the lowest risk and development time would be to incrementally improve the existing technology by selecting new materials and using FEA (finite element analysis) stress modelling to improve the design.
Jeremy Carey, 42 Technology's Engineering Manager explained: "A wide range of the latest commercially available friction materials were identified, their specification and applicability to this particular requirement reviewed and a short list of candidate materials were rigorously tested".
"A number of materials were proven to be more effective than the original material, including the final selection which provided approximately double the coefficient of friction of the original material, but at a fraction of the cost".
42 Technology then carried out an extensive design study, using the FEA capabilities of Pro-Mechanica.
This indicated that the company would be able to make design recommendations that would result in a weight reduction of the assembly by approximately a factor of two while keeping the stress deflection to the same level experienced by the original design.
The work was then expanded to consider systems comprising two or three brakes.
Peter Everitt, Crane Electronics Commercial Director, was delighted by the success of this focused project reporting that "Together the design improvements identified by 42 Technology lead to a new product that was half the size, weight and cost of the original design".
• 42 Technology: contact details and other news
• Email this article to a colleague
• Register for the free Engineeringtalk email newsletter
• Engineeringtalk Home Page
Search the Pro-Talk network of sites
